USB compatible cable for in-circuit configuration and programming of all Xilinx devicesOverviewThe Platform Cable USB a USB compatible cable for in-circuit configuration and programming of all Xilinx devices. It is compatible with the original XILINX Platform Cable USB.FeaturesPerformance Using CY7C68013A+FPGA solution, fully compatible with the original XILINX Platform Cable USB Programs all Xilinx devices, including FPGAs / CPLDs / ISP Configuration PROMs Supports JTAG, Slave-Serial and SPI programming, to config all Xilinx devices Interfaces to devices operating at 5V / 3.3V / 2.5V / 1.8V / 1.5V Optional target clock frequency, supports XILINX software automatic frequency adjustment Firmware auto upgrade, it's possible to support more new released software and devices Anti-static and multi-layers signal isolation, to protect the target and the programmer itself Supported software Xilinx ISE iMPACT ChipScope Vivado Supported devices Xilinx FPGA devices: UltraScale / 7 series / Zynq / Kintex / Virtex / Artix / Spartan, etc. Xilinx CPLD devices: XC9500 / XC9500XL / XC9500XV / CoolRunner XPLA3 / CoolRunner-II, etc. Xilinx PROM devices: Platform Flash XCF00S / XCF00P / XL, etc.LED StatusRed: USB connected Yellow: USB connected, and Vref (the target board) is poweredHow to ConnectConnects to PC Via USB interface Connects to target board Platform Cable USB provides 3 different interfaces to connect with the target board: JTAG, Slave Serial, and SPI. The figure below shows the header pino